|
Summit
Construction Manual - Step 7 |
STEP 7 A
- Tundra Wheel Assembly
(OPTIONAL)
|
PARTS |
|
QUANTITY |
PART # |
Name |
|
2 |
HEG 1850 |
TUBES |
|
2 |
HEG 1800 |
TIRES |
|
2 |
HEG 1200-5/8 |
HUB FOR 5/8 AXLE |
|
2 |
HEG 1010 |
SPACER |
|
2 |
HEG 1000 |
RIMS |
|
4 |
5/8 W/W |
WHEEL WASHER |
|
2 |
5/8 W/N |
WHEEL NUTS |
|
6 |
HUB BOLT 5/16 |
CAP HEAD BOLTS |
First you must install rims on the tundra tires.
The HEG 1200 hub goes on the inside of the skinny aluminum rim. Take
care not to pinch the tube. Make sure both rim halves are together
before inflating to 14 psi.
Click on illustration below to view larger version!
Continue by placing one 5/8 W/W wheel washer on the
axle sticking out of the S3-2 main gear support. Place a complete tire
and rim on, the one 5/8W/W wheel washer, the one HEG 1010 spacer and
secure with 5/8 W/N wheel nut. Tighten then back off until wheel spins
freely.
Repeat for the other side.
( next
- Step 22 ) ----->
|
